Installing Batteries Into Wheelchairs Without Elevate - Invacare TDX 4 Owner's Operator And Maintenance Manual

SECTION 10—TDX, FORMULA TRE, 2G TARSYS AND FORMULA PTO PLUS BATTERIES
NOTE: Battery
cables not shown for
clarity.
YELLOW Battery
Connector Tab
FIGURE 10.4 Removing the Batteries from Wheelchairs without Elevate

Installing Batteries into Wheelchairs without Elevate

NOTE: For this procedure, refer to FIGURE 10.3 on page 110 and FIGURE 10.5 on page 112.
NOTE: Positioning of the batteries into the battery tray is completed with battery tray positioned
in wheelchair and partially pulled out. Refer to FIGURE 10.3 for full view of wheelchair base.
Illustrations in FIGURE 10.5 are shown without the wheelchair for clarification purposes only.
1. Position the battery with battery connector bracket in the REAR of the battery tray in
the orientation as shown. See DETAIL "A".
NOTE: Front of battery tray is designated by the battery stop. Rear of the battery tray is the
opposite end.
NOTE: Orientation of the battery is critical otherwise batteries will not connect to the controller
or each other.
2. Position the remaining battery in the FRONT of the battery tray in the orientation
shown so that the wiring harnesses can be connected together. See DETAIL "B".
3. Connect front battery to rear battery. See DETAIL "B".
4. Connect battery straps. See DETAIL "C".
5. Slide the battery tray into the wheelchair.
NOTE: Refer to FIGURE 10.3 on page 110.
Part No 1114809
REAR OF WHEELCHAIR
FRONT OF WHEELCHAIR
111
Disconnect Batteries
from Controller Here
Rear Battery
Battery Box
BLACK Battery
Connector Tab
Front Battery
TDX™ Wheelchairs