Installing/Removing The Power Elevating Legrests; Installing The Power Elevating Legrests; Removing The Power Elevating Legrests - Invacare TDX 4 Owner's Operator And Maintenance Manual

2. Move the calf pad to the desired position.
3. Install the two height/width adjustment screws to secure the calf pad to the calf pad
mounting bracket.
4. Check operation of the calf pads to ensure there is no interference with the seat pan or
the carriage assembly. If there is interference, readjust calf pad.
5. Repeat STEPS 1 to 4 for the opposite side, if desired.

Installing/Removing the Power Elevating Legrests

To prevent personal injury, always verify proper positioning of legs and feet prior to
use. Individual user weight may impact the rate of travel for each legrest assembly.
If simultaneous operation is desired, select a speed which allows for the most
uniform travel.
DO NOT insert fingers between legrest components, otherwise personal injury may
occur.
Never allow items to become trapped between the legrest assemblies, otherwise
damage to the power legrests may occur.
Ensure that all parts of both power legrests are clear of any obstructions before rais-
ing and lowering, otherwise damage to the power legrests may occur.
NOTE: For this procedure, refer to FIGURE 6.23 on page 84.
NOTE: Power legrests are linked to the recline function of the powered seating system. Operating
the recline function automatically operates power legs. Power legrests can also be operated
independently of the recline function.

Installing the Power Elevating Legrests

1. Turn power legrest to side (open footplate is perpendicular to wheelchair) (Detail "A"
of FIGURE 6.23).
2. Insert the mounting pin of power legrest into the mounting hole of the seat frame
(Detail "A" of FIGURE 6.23).
NOTE: Make sure the legrest sits flush on the seat frame.
3. Rotate the power legs toward the INSIDE of the wheelchair until it locks in place.
NOTE: The footplate will be on the INSIDE of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. Connect power legrest connector to jumper cable (Detail "B" of FIGURE 6.23).

Removing the Power Elevating Legrests

1. Disconnect power legrest connector from jumper cable.
Part No 1114809
SECTION 6—FRONT RIGGINGS
WARNING
CAUTION
83
TDX™ Wheelchairs