Adjusting Mechanical Elevating Legrests; Calfpads; Footplate Height - Invacare TDX 4 Owner's Operator And Maintenance Manual

SECTION 6—FRONT RIGGINGS

Adjusting Mechanical Elevating Legrests

Calfpads

NOTE: For this procedure, refer to FIGURE 6.26.
1. Turn the calfpad toward the outside of the wheelchair.
2. Slide calfpad up or down until desired position is obtained.
3. Turn the calfpad toward the inside of the wheelchair.
FIGURE 6.26 Adjusting Mechanical Elevating Legrests - Calfpads

Footplate Height

NOTE: For this procedure, refer to FIGURE 6.27.
NOTE: The following procedure should be performed with the user in the wheelchair.
1. Loosen, but DO NOT remove, the bolt and locknut that secure the lower legrest
assembly to the upper legrest assembly.
2. Move the lower legrest assembly to the desired position for the user.
3. While holding the lower legrest in position, tighten the bolt and locknut securely.
4. Repeat STEPS 1-4 for opposite legrest if necessary.
Upper Legrest
Assembly
Bolt/Nut
Lower Legrest
Assembly
FIGURE 6.27 Adjusting Mechanical Elevating Legrests - Footplate Height
TDX™ Wheelchairs
Adjust Calfpad Adjust Calfpad
86
Secure Calfpad
Part No 1114809