Installing The Battery Door And Rear Shroud - Invacare TDX 4 Owner's Operator And Maintenance Manual

SECTION 10—TDX, FORMULA TRE, 2G TARSYS AND FORMULA PTO PLUS BATTERIES
NOTE: Battery
cables not shown for
clarity.
Left Battery
Connector
YELLOW Battery
Connector Tab
FIGURE 10.6 Installing Batteries into Wheelchairs with Elevate

Installing the Battery Door and Rear Shroud

Wheelchairs with TRRO or TRBKTS Only - Battery support brackets MUST be
installed at all times. Otherwise, the wheelchair will not be WC/19 compliant.
After installing battery door, ensure that the mounting screws on the side of the
battery door are fully engaged into the side of the battery box.
NOTE: For this procedure, refer to FIGURE 10.1 on page 107 and FIGURE 10.2 on page 108.
1. Wheelchairs with TRRO and TRBKTS Only - Install the battery support bracket onto
the battery box (FIGURE 10.2 on page 108) using the four hex screws and four
locknuts (if applicable). Torque to 75 in-lbs.
NOTE: The installation of the battery support bracket depends on the type of battery and options
on the wheelchair. Refer to the correct configuration in FIGURE 10.2 on page 108.
2. Reinstall battery door onto front of wheelchair.
3. Install both mounting screws on the side of the battery door.
NOTE: Ensure that the mounting screws on the side of the battery door are fully engaged into the
side of the battery box.
Part No 1114809
REAR OF WHEELCHAIR
FRONT OF WHEELCHAIR
WARNING
113
Disconnect Batteries
from Controller Here
Rear Battery Rear Battery
Battery Box
Right Battery
Connector
BLACK Battery
Connector Tab
Front Battery
TDX™ Wheelchairs