Side Rail
Side Rail
Cap Screws
NOTE: Formula TRE seat frame shown. Telescoping front rigging supports install in the
same way on the ASBA seat frame.
FIGURE 6.7 Adjusting/Replacing Telescoping Front Rigging Support - Wheelchairs without
Installing Adjustable Angle Flip-up Footplate Hinge
NOTE: For this procedure, refer to FIGURE 6.8.
1. Position footplate hinge on the footrest
support tube at the desired height.
2. Position mounting screw, washers,
spacer, and locknut on the footrest
support as shown (FIGURE 6.8).
3. Flip the footplate hinge to the up
position.
NOTE: The footplate hinge will fall to the down
position.
4. Tighten the mounting screw, washer, and locknut that secure the footplate hinge to the
footrest support until the footplate hinge remains in the up position.
5. Check the up and down motion of the footplate hinge to make sure the user of the
wheelchair can operate the footplates easily.
NOTE: If footplate's motion is too tight, loosen the mounting screw and locknut approximately
¼-turn counterclockwise.
NOTE: If the footplate's motion is too loose, tighten mounting screw and locknut approximately
¼-turn clockwise.
6. Adjust footplate. Refer to Installing Adjustable Angle Flip-up Footplates on page 72.
Part No 1114809
Side Rail
Threaded
Spacers
2G Tarsys Systems
Footplate
Hinge
Locknut
Spacer
FIGURE 6.8 Installing Adjustable Angle
71
SECTION 6—FRONT RIGGINGS
Spacers
Cap Screws
Blocks
Telescoping
Front Tube
Mounting Screw
Washers
Footrest Support
Flip-up Footplate Hinge
TDX™ Wheelchairs