Raising/Lowering Elevating Legrests And/Or Adjusting Calfpads; Raising/Lowering Elevating Legrests; Adjusting Calfpads; Removing/Installing The Center Mount Footrest - Invacare TDX 4 Owner's Operator And Maintenance Manual

Raising/Lowering Elevating Legrests and/or Adjusting
Calfpads
NOTE: For this procedure, refer to FIGURE 6.14.
Raising/Lowering Elevating
Legrests
1. Perform one of the following:
• RAISING - Pull back on the release
lever until the leg is at the desired
height.
• LOWERING - Support leg with one
hand and push release lever
downward with other hand.

Adjusting Calfpads

1. Turn the calfpad towards the outside of
the wheelchair.
2. Slide the calfpad UP or down until the
desired position is obtained.
NOTE: If one of the top two calfpad adjustment positions is being used, the legrest will need to be
raised to avoid interference with the front stabilizers while going over obstacles or going UP and
down ramps. Refer to Raising/Lowering Elevating Legrests on page 75.
3. Turn the calfpad towards the inside of the wheelchair.

Removing/Installing the Center Mount Footrest

NOTE: For this procedure, refer to FIGURE 6.15 on page 77.

Removing

Power Center Mount Footrests
1. Remove the short quick-release pin that secures the center mount rigging to the link
plate (Detail "A").
2. Remove the rigging pivot pin that secures the center mount rigging to the top of the
support (Detail "B").
3. Remove the long quick-release pin that secures the center mount rigging to the center
support (Detail "C").
NOTE: The link drive tube will fall out when the long quick-release pin is removed. Retain for
proper reinstallation.
Part No 1114809
SECTION 6—FRONT RIGGINGS
Legrest to Normal Position
Adjust Calfpad
FIGURE 6.14 Raising/Lowering Elevating
Legrests and/or Adjusting Calfpads
75
Secure Calfpad
TDX™ Wheelchairs