SECTION 6—FRONT RIGGINGS
Calfpad Height
NOTE: For this procedure, refer to FIGURE 6.29.
1. Turn the calfpad towards the outside of the wheelchair.
2. Slide calfpad up or down until desired
position is obtained.
3. Turn the calfpad towards the inside of
the wheelchair.
Calfpad Depth
NOTE: For this procedure, refer to
FIGURE 6.29.
1. Remove the hex bolt and locknut that
secure the calfpad and spacer to the
adjustment bracket.
2. Move the legrest to one of three
positions.
3. Reinstall the hex bolt through the
spacer and calfpad.
NOTE: Make sure hex bolt sits flush
adjustment bracket channel.
4. Reinstall locknut onto the hex bolt and tighten securely.
Legrest Height
NOTE: For this procedure, refer to FIGURE 6.30.
1. Remove the button screw that secures the adjustment link and two washers to the
legrest support.
2. Move adjustment link to one of three positions.
3. Line up the two washers and adjustment link with the mounting hole in the legrest
support.
4. Install the button screw and tighten securely.
Button Screw
FIGURE 6.30 Adjusting Genius Legrests - Legrest Height
TDX™ Wheelchairs
Washer
Legrest Support
88
Locknut
Bracket Channel
Calfpad
Adjustment
Bracket
Spacer
FIGURE 6.29 Adjusting Genius Legrests -
Calfpad Height/Calfpad Depth
Washer
Adjustment Link
Adjustment
Hex Bolt
Part No 1114809