Installing Batteries Into Wheelchair - Invacare TDX SI Service Manual

FIGURE 9.3 Removing the Batteries from Wheelchair

Installing Batteries into Wheelchair

Risk of Serious Injury
Improperly installed battery tray can cause instability resulting in serious injury.
Ensure batteries and battery tray are installed properly to maintain stability.
NOTE: For this procedure, refer to FIGURE 9.3 on page 73 and FIGURE 9.4.
NOTE: Positioning of the batteries into the battery tray is completed with battery tray positioned
in wheelchair and partially pulled out. Refer to FIGURE 9.3 for full view of wheelchair base.
Illustrations in FIGURE 9.4 are shown without the wheelchair for clarification purposes only.
1. Position the battery with battery connector bracket in the rear of the battery tray in the
orientation as shown (Detail "A" of FIGURE 9.4).
NOTE: Front of battery tray is designated by the battery stop. Rear of the battery tray is the
opposite end.
NOTE: Orientation of the battery is critical otherwise batteries will not connect to the controller
or each other.
2. Position the remaining battery in the front of the battery tray in the orientation shown
so that the wiring harnesses can be connected together (Detail "B" of FIGURE 9.4).
3. Connect front battery to rear battery (Detail "B" of FIGURE 9.4).
4. Connect battery straps (Detail "C" of FIGURE 9.4).
5. Slide the battery tray into the wheelchair (FIGURE 9.3).
6. Install the battery door and rear shroud. Refer to Installing the Front Shroud/Battery
Retention Bracket and Rear Shroud on page 74.
Part No 1160845
FRONT OF WHEELCHAIR
Battery Tray
WARNING
73
SECTION 9—BATTERIES
Rear Battery
Disconnect Front Battery
from Rear Battery Here
Front Battery
Battery Straps
TDX® SI/SI-HD