Replacing Batteries - Invacare TDX 4 Owner's Operator And Maintenance Manual

SECTION 9—HANDLING AND REPLACING BATTERIES
FOR TDX WHEELCHAIRS, 2G TARSYS SYSTEMS, FORMULA PTO PLUS
SEATING SYSTEMS AND FORMULA TRE SEATING SYSTEMS THAT USE GP24
Batteries with terminal configuration (POSITIVE on the right and NEGATIVE on
the left) as shown below MUST be used. Batteries that have the reverse terminal
configuration MUST not be used - otherwise injury and damage may occur.
Terminals MUST have a cross hole in them as shown below.
PROPER BATTERIES TO USE
Terminal
Cross
Hole

Replacing Batteries

NOTE: For this procedure, refer to FIGURE 9.1 on page 102, FIGURE 9.2 on page 103 or
FIGURE 9.3 on page 104.
NOTE: The following tools are required to perform this procedure.
• Wire Cutter
1. Remove the batteries from the wheelchair. Refer to one of the following sections:
• NO Powered Seating System - TDX, Formula TRE, 2G TARSYS and Formula PTO
Plus Batteries on page 106.
• Formula TRE Systems - TDX, Formula TRE, 2G TARSYS and Formula PTO Plus
Batteries on page 106.
• Formula PTO Plus Systems - TDX, Formula TRE, 2G TARSYS and Formula PTO
Plus Batteries on page 106.
• Formula Invisible Super Low Tilt Systems - Formula Invisible Super Low Tilt
Batteries on page 115.
• 2G Tarsys Systems - TDX, Formula TRE, 2G TARSYS and Formula PTO Plus
Batteries on page 106.
2. Cut the tie-wraps that secure the battery terminal covers to the battery terminals.
3. Slide the RED battery terminal cover back on the RED battery cable to expose the
POSITIVE battery terminal.
4. Slide the BLACK battery terminal cover back on the BLACK battery cable to expose
battery terminal.
TDX™ Wheelchairs
WARNING
BATTERIES
DO NOT USE THIS TYPE BATTERY
POSITIVE (+)
POSITIVE
Battery
(+) Battery
Terminal/Post
Terminal/
Post
NEGATIVE
(+) Battery
Terminal/Post
100
NEGATIVE
(+) Battery
Terminal/Post
Part No 1114809