SECTION 6—FRONT RIGGINGS
Calf Pad Adjustment for Power Center Mount Footrests
NOTE: For this procedure, refer to FIGURE 6.22.
NOTE: Ensure footrest height has been adjusted before performing this procedure. Refer to
Adjusting the Height of the Center Mount Footrest on page 78.
Depth Adjustment
1. Remove the two depth adjustment screws securing the calf pad mounting bracket to
the carriage assembly.
2. Move the calf pad mounting bracket to the desired position.
3. Install the two depth adjustment screws to secure the calf pad mounting bracket to the
carriage assembly.
4. Check operation of the calf pads to ensure there is no interference with the seat pan or
the carriage assembly. If there is interference, readjust calf pad.
5. Repeat STEPS 1 to 4 for the opposite side, if desired.
Carriage
Assembly
Height/
Width
Adjustment
Screws
Depth Adjustment
Screws
FIGURE 6.22 Calf Pad Adjustment for Power Center Mount Footrests
Height and Width Adjustment
1. Remove the two height/width adjustment screws securing the calf pad to the calf pad
mounting bracket.
TDX™ Wheelchairs
Calf Pad
Mounting Bracket
Calf Pad
82
Part No 1114809