70° Taper; Footrest Height Adjustment; 70° And Pw93 - Invacare TDX 4 Owner's Operator And Maintenance Manual

SECTION 6—FRONT RIGGINGS
70° Taper
NOTE: For this procedure, refer to FIGURE 6.2
1. Turn the footrest to the side (open
footplate is perpendicular to
wheelchair).
2. Insert footrest mounting pin into
mounting tube.
3. Push the footrest towards the INSIDE
of the wheelchair until it locks into
place.
NOTE: The footplate will be on the INSIDE of the wheelchair when locked in place.
4. Repeat STEPS 1- 3 for the other footrest assembly.
5. To remove the footrest, push the footrest release lever inward, rotate footrest outward.
6. Adjust footrest height, if desired. Refer to Footrest Height Adjustment on page 68.

Footrest Height Adjustment

Minimum ground clearance for the footrest is 3 inches - otherwise personal injury or
damage may result.
70° and PW93
NOTE: For this procedure, refer to
FIGURE 6.3.
1. Remove any accessory from the
footrest(s).
2. Remove the footrest from the
wheelchair. Refer to Installing/
Removing Footrests on page 67.
NOTE: Lay the footrest on a flat surface to simplify this procedure.
3. Remove the mounting screw, washers and locknut that secure the lower footrest
assembly to the upper footrest support (FIGURE 6.3).
4. Reposition the lower footrest to the desired height.
5. Reinstall the mounting screw, washers and locknut that secure the lower footrest to
the footrest support and tighten securely.
TDX™ Wheelchairs
Mounting Tube
Footplate
FIGURE 6.2 Installing/Removing Footrests -
WARNING
Locknut
Lower Footrest
Assembly
FIGURE 6.3 Footrest Height Adjustment -
68
Footrest
Mounting Pin
Footrest
Release
Lever
70° Taper
Upper Footrest Support
Mounting Screw
Washer
70° and PW93
Part No 1114809