Table of Contents
Advertisement
【Protocol Settings】You can transmit the data stream from the IP cameras using the RTSP (Real Time
Streaming Protocol) on the network. The RTSP is a protocol that allows you to access video streams by
using the compatible media players. Click Apply to apply the changes or Cancel to cancel the changes
and return to the previous settings.
RTP over UDP: The RTSP protocol uses UDP for camera data stream transmission.
RTP over TCP: The RTSP protocol uses TCP for camera data stream transmission.
RTP over HTTP: The RTSP protocol uses HTTP for camera data stream transmission.
Nevio CGI: This is EverFocus' protocol designed for EverFocus' IP devices. Select this protocol for
camera data stream transmission.
【IP Settings】Enter the IPv4 / IPv6 details in this area, which applies to your system. Click Apply to
apply the changes or Cancel to cancel the changes and return to the previous settings.
IPv4:
IP Mode: Refer to the network administrator for these settings of the server. Default: DHCP.
DHCP: This setting lets the system use an automatically assigned (dynamic) IP address. This
•
address can change under certain circumstances. For instance, when the camera's network
switch/hub has to be rebooted. Do not assign to the DHCP server the same IP addresses used
for the other network cameras and PCs with unique IP addresses.
Static IP: The user can manually set the Static IP address. This type of address is stable and
•
cannot change, but the user has to make sure there are no address conflicts with other
network-connected devices.
PPPoE: This is a DSL-connection application. The ISP will ask the user to input a username and
•
password. Contact your ISP for these details.
Note: If PPPoE is selected as the IP type, the supplied IP Utility program will not be able to
detect the device.
IP address: When DHCP is not used, the user needs to manually enter the IP address of the camera.
Do not enter an IP address that is already used for your computer or other network cameras.
Subnet Mask: This field is used to set the subnet mask for your network, so that the IP camera will
be recognized within the network. Example: 255.255.255.0. When DHCP is selected, the DHCP
server will assign this value automatically.
Gateway: This field is used to set the gateway for your network so that the IP camera will be
recognized within the network. When DHCP is selected, the DHCP server will assign this value
automatically.
Primary DNS: Enter the IP address of the DNS server if this is provided by an ISP.
Secondary DNS: If your ISP provided you with a secondary DNS address, please enter it here.
Username: Enter the account's username (used only for PPPoE).
Password: Used only for PPPoE.
IPv6: Enter the IPv6 details in this area, if this applies to your system.
28
EZN1160/1260/1360
Advertisement
Table of Contents
