EverFocus True Day/Night, WDR, IP66 User Manual page 61

Note: The recording will only be as long as the combined Pre- and Post-trigger Buffers, so
make sure you enable at least one of these buffers, especially the Post-trigger Buffer.
Network Alarm: Check the box if you want the camera to send a network alarm signal (when the

event occurs) to the CMS servers. Note that you have to configure the Network Alarm Settings
for this function to work (see 7.3.3 Notification).
: Set up the Event information and click the Create button, the created Event information
will be listed in the Event List.
: Highlight an item in the Event List and then click the Remove button to remove the
highlighted item.
: Highlight an item in the Event List and edit the Event information on the left-side. Click the
Edit button and the item will be edited.
: Click the button to cancel the changes and return to the previous settings.
【Event Trigger Settings】 Select Normal Open or Normal Close for the Input / Output type.
【Trigger Options Settings】
Pre-trigger Buffer: Select the duration for the buffer. This will determine the amount of footage

(length of time) before the event trigger moment that will be included in an event-triggered
video recording, if that buffer and video recording has been enabled in the Event Management
field.
Post-trigger Buffer: Select the duration for the buffer. This will determine the amount of footage

(length of time) after the event trigger moment that will be included in an event-triggered video
recording, if that buffer and video recording has been enabled in the Event Management field.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
【Schedule Settings】Users can configure the recording schedule here. Select the desired recording
types among the options below. Click and drag the cursor on the time block, which will be applied
with the selected recording type.
Event Recording (Red): Select for the camera to activate all the Event Recording set up in the

Event Management field (Event Trigger Type), except the Schedule Recording.
Schedule Recording (Green): Select for the camera to activate only the Schedule Recording set

up in the Event Management field (Event Trigger Type).
Event + Schedule (Yellow): Select for the camera to active both of the configured Event and

Schedule Recordings.
Deselect (Grey): Select for the camera to stop recording.

Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
55
EZN1160/1260/1360