S8500 Leds - Avaya S8500 Installing And Configuring

Chapter 9: Installation verification

S8500 LEDs

The Avaya S8500 Media Servers have five or six LEDs on the front and four LEDs on the back.
The S8500B and S8500C have the same LEDs but in different locations. The S8500B can have
an additional LED indicating activity on the optional floppy disk drive. The S8500C does not
support a floppy disk drive.
The SAMP module has no LEDs.
See Figure 1: S8500C front panel
for the locations of the front-panel LEDs on the S8500C and S8500B.
The functions of the front-panel LEDs are as follows:
Table 7: S8500 front-panel LEDs
LED
Power on
Hard disk drive
Locator
System error
CD-ROM drive
Floppy disk drive
(S8500B only)
Figure 13: Rear view of S8500B Media Server
the back panel of the S8500B. Each port connector has two LEDs, one for transmission activity
and one to indicate the transmission speed. The port LEDs on the S8500C are the same as on
the S8500B.
90
Installing and Configuring the Avaya S8500 Media Server
on page 15 and Figure 3: S8500B front panel
When lit and not flashing, the media server is turned on.
When flashing, the media server is turned off and still
connected to the AC power source. When off, AC power is
not present, or the power supply or the LED failed.
When on or blinking, indicates HDD activity.
Use this blue LED to locate the media server if the media
server is in a location with numerous other media servers.
When on, indicates a system error.
When on or blinking, indicates activity on the CD-ROM drive.
When on or blinking, indicates activity on the FDD drive.
on page 91 shows the Ethernet port LEDs on
Description
on page 16
June 2006