Establishing Equipotential Bonding - DURKOPP ADLER 867 Operating Manual

94

7.12.3 Establishing equipotential bonding

DANGER
Danger to life due to electric shock.
Disconnect the power plug before establishing
equipotential bonding.
Make sure the power plug cannot be unintention-
ally reinserted.
The earthing cable conducts away any static charging of the
machine upper section.
Figure 65: Establishing equipotential bonding
(1) - Connection at the controller
1. Tilt the machine upper section.
2. Feed the earthing cable from the connection (1) on the rear
side of the controller through the cutout in the table plate and
plug it onto the tab connector (2) on the base plate.
1
(2) - Tab connector
Operating manual 867 Version 01.0 - 12/2012
Set-up instructions
2