Operating instructions
Automotive:
Blockable
adjusters
Operating manual 867 Version 01.0 - 12/2012
5.6.2 Removing blocking of the needle thread tension
Machines with blockable adjusters are used especially in the
automotive sector. With these machines the blocking must be
removed before the sewing foot pressure can be adjusted.
Figure 20: Removing blocking of the needle thread tension
1 2 3 4
(1) - Fastening screw
1. Loosen the fastening screws (1).
2. Remove the retaining plate (2).
3. Adjusting the needle thread tension
( Section 5.6.1 Adjusting the needle thread tension,
Page 38).
4. Fit the retaining plate (2).
5. Tighten the fastening screws (1).
5.6.3 Opening the needle thread tensioner
•
ECO machines:
The needle thread tensioner is automatically opened when
the sewing foot is lifted via the knee lever.
•
CLASSIC machines:
The needle thread tensioner is automatically opened when
the thread is cut.
1
2
(2) - Retaining plate
41