Set-up instructions
Operating manual 867 Version 01.0 - 12/2012
7.4.2 Completing a long arm table plate
Figure 50: Completing a long arm table plate
1
2
3
(1) - Cable duct
(2) - Cutout for hinge lower parts
(3) - Drawer
(4) - Oil pan
1. Screw the drawer (3) with the left-hand bracket to the under-
side of the table plate.
2. Screw the oil pan (4) in place under the recess for the machine.
3. Screw the cable duct (1) to the underside of the table plate.
4. Insert the thread reel holder (7) in the hole.
5. Fasten the thread reel holder (7) with nut and washer.
6. Screw the thread real holder and the unwinding bracket onto
the thread reel holder (7) in such a way that they are exactly
opposite each other.
7. Insert the plug (6) in the hole.
8. Fit the lower part of the hinge into the recess (2).
9. Fit the rubber corners in the corner protrusions (5).
7
6
5
4
(5) - Corner protrusions
(6) - Hole
(7) - Thread reel holder
79