Operation - Extron electronics DTP DVI 301 User Manual

RS-232 and IR connector wiring
Figure 11 shows how to wire the RS-232 connector.
Tx/Rx
Pins
Figure 11.
NOTE:

Operation

Figure 12 shows the location of the power indicators on the front and rear panels of the
transmitter and receiver and the DIP switches on the transmitter.
1
Figure 12.
a
b
c
NOTE:
Connected RS-232
and IR Device Pins
Transmit pin on connected unit
Receive pin on connected unit
Ground
Transmit pin on connected unit
Receive pin on connected unit
RS-232 Connector Wiring
The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
See the NOTE on page 6 for details.
Do not tin the power supply leads before installing them in the connector.
Tinned wires are not as secure in the connector and could be pulled out.
POWER
12V
0.7 A MAX
Front Rear
(Both Units) (Tx)
Power Indicator and DIP Switches
Power (and signal) LED (front panel) —
Amber — The unit is receiving power, either locally or remotely (on the DTP cable).
Green — The unit is receiving an active DVI input, either on the DVI input if a
transmitter, or transmitted on the DTP cable if a receiver.
Power LED (rear panel) —
Amber — The unit is receiving power remotely (on the DTP cable).
Green — The unit is receiving power locally.
DDC Route switch — This rear panel switch selects either the remote or local DVI
display as the DDC reference (for EDID and HDCP communications).
NOTE: HDCP content can be played on either the remote or local display only,
depending on the DDC Route switch position.
After the transmitter, the receiver, and their connected devices are powered up, the system is
fully operational. If any problems are encountered, ensure all cables are routed and
connected properly.
Ensure that the video source and display selected for the DDC are properly
connected to the transmitter and receiver pair, and that the transmitter, the
receiver, and the display have power applied before power is applied to the
video source. If the other devices are not turned on before the video source, the
image may not appear.
DDC ROUTE
REMOTE
ON
1 2
SPARE LOCAL
2 3
DTP DVI 301 • Installation and Operation 11