Table of Contents
Advertisement
c
Audio connector — If desired, plug an analog audio input into the transmitter via
this stereo mini jack connector.
NOTES:
•
The analog audio input on this connector is in addition to the digital audio
that is embedded in the DVI input.
•
See the figure at right to identify the tip, ring,
and sleeve when you are making connections
for the transmitter from existing audio cables.
A mono audio connector consists of the tip
and sleeve. A stereo audio connector consists
of the tip, ring, and sleeve.
d
RS-232 and IR connector — Connect a serial RS-232 signal, a modulated IR signal,
or both to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232 and IR
communication. See
"RS-232 and IR connector
e
DTP and Analog Audio Output RJ-45 connectors — Connect one end of one
(or two) TP cables to these RJ-45 female connectors on the transmitter.
CAUTION: Do not connect this device to a computer data or telecommunications
network.
NOTE:
See
"TP cable
detailed NOTES.
à
DTP Output connector (Required) — Ensure the free end of this cable is
connected to the receiver DTP In connector
•
TMDS (digital) video
•
Embedded audio (if any)
•
Bidirectional RS-232 and IR commands and data
•
Remote power
Signal LED — This LED lights when the unit is receiving a TMDS clock signal on
the DVI input (transmitter) or any valid signal on the DTP In connector (receiver).
Link LED — This LED lights when a valid link is established between the units on
the DTP input and output cable.
â
Analog Audio Output connector (Optional) — If desired, ensure the free
end of this cable is connected to the receiver Analog Audio In connector
This cable carries analog audio only and is not needed for applications that do not
require this audio signal.
f
Power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector or the power input connector on the receiver
"Power supply
wiring" to wire the connector.
NOTE:
One power supply can power both units. A power supply is included with
the transmitter.
wiring" to wire the connector.
termination" to properly wire the RJ-45 connectors and for
(item
DTP DVI 301 • Installation and Operation
Tip (+)
Ring (-)
Sleeve ( )
3.5 mm Stereo Plug Connector
(balanced)
å
). This cable carries:
(item
(item
k
ç
).
). See
4
Advertisement
Table of Contents
