Table of Contents
Advertisement
The transmitter is shipped with a single external desktop 12 VDC power supply that
accepts 100 to 240 VAC, 50-60 Hz input. A single power supply connected to either the
transmitter or the receiver can power both units through the TP cable that carries DVI video.
TP Cable Advantages
Twisted pair cable is much smaller, lighter, more flexible, and less expensive than coaxial or
DVI cable. These transmitter and receiver twisted pair (TP) products make cable runs simpler
and less cumbersome. Termination of the cable with RJ-45 connectors is simple, quick, and
economical.
NOTE:
Control Communications
The RS-232 and IR communications are via a passive pass-through only; the transmitter and
receiver do not generate or respond to these signals.
Features
Transmits single link DVI signals over a singleCAT 5e, CAT 6, or CAT 6a cable —
Standard twisted pair cables provide an economical, easily installed cable solution.
Transmits analog audio signals over a separate, optional CAT 5e or CAT 6 cable —
Standard twisted pair cables provide an economical, easily installed cable solution.
Long distance transmission — Up to 100 feet (330 m)
Supports Display Data Channel (DDC) transmission — The transmitter and receiver pair
fully supports long distance transmission of the DDC signals.
Control communications pass-through — Bidirectional RS-232 and IR control signals
can be transmitted alongside the DVI signal, so that the remote display can be controlled
without the need for additional cabling.
Supports CEC signal transmission with the appropriate DVI-to-HDMI adapters
1-inch high, quarter rack width, metal enclosures — With low profile enclosures, the
transmitter and receiver can be discreetly installed in locations such as behind a plasma or
LCD flat-panel display.
External 100 VAC to 240 VAC, 50-60 Hz, international power supply
(part number 70-775-01) — Included with the transmitter
Remote powering of transmitter or receiver — Only one power supply is necessary to
power both devices.
Do not use Extron UTP23SF-4 Enhanced Skew-Free
STP201 cable to link the transmitter and receiver. The DTP DVI 301 Tx/Rx does
not work properly with these cables.
AV UTP cable or
™
DTP DVI 301 • Introduction
2
Advertisement
Table of Contents
