Axu-Mlc (/Pb) And Bb-Mtp (Solid Surfaces) - AMX LCD Mini-Touch Panels Instruction Manual

Note
The mini-touch panel must
always be installed with the
release slot located at the
bottom.
Figure 6
AXU-MLC (/PB) and BB-MTP
UniMount enclosure for solid
surfaces
Black/White LCD Mini-Touch Panels
Fasten the AXU-MLC (/PB) and low profile back box to the surface using the
6.
#6-32 machine screws supplied with the enclosure.
Insert the engraved overlay back into the bezel.
7.
Connect the AXlink wiring to the AMX control system, and RS-232 wiring
8.
(optional) to the external RS-232 device. The AXU-MLC (/PB) will beep when
you apply power.

AXU-MLC (/PB) and BB-MTP (solid surfaces)

Mount the AXU-MLC (/PB) and BB-MTP ( Figure 6) into a solid surface:
BB-MTP UniMount enclosure
Stud mounting
holes
Cut the solid surface according to the cutout dimensions shown in Figure 7.
1.
Insert a flat head screwdriver into the release slot on the AXU-MLC (/PB)' s
2.
bezel and remove the engraved overlay.
Solid surface mounting
flanges
Knockout
AXU-MLC bezel
Release slot
Engraved overlay
Installing the Mini-Touch Panel 7