Figure 11
AXW-MLC (/PB) wood
enclosure
12
Installing the Mini-Touch Panel
Connect the AXlink and RS-232 wiring to the AXM-MLC circuit card. Refer to
3.
Wiring the Mini-Touch Panel for complete wiring information.
Insert the AXM-MLC into the rack. Line up the top left and right screw holes
4.
and start the #6-32 screws. Then, start the bottom left and right screws. Tighten
all the screws after you start all the screws.
Connect the AXlink wiring to the AMX control system and RS-232 wiring to the
5.
external RS-232 device. The AXM-MLC will beep when you apply power.
AXW-MLC (/PB) (wood enclosure)
Install the AXW-MLC (/PB) ( Figure 11) wood enclosure:
Thread the incoming AXlink cable to the AXW-MLC (/PB).
1.
Disconnect the AXlink connector from the AMX control system that supplies
2.
power and data to the AXW-MLC (/PB).
Connect the mini-XLR connector to the AXW-MLC (/PB). Refer to Wiring the
3.
Mini-Touch Panel for complete wiring information.
Connect the AXlink wiring to the AMX control system. The AXW-MLC (/PB)
4.
will beep when you apply power.
Black/White LCD Mini-Touch Panels