Mounting The Decor-Style Panel On Plasterboard/Drywall - AMX AXD-CP4/PB Instruction Manual

10. Fasten the main AXD unit to the surface using the surface-screws (#4 wood screws) supplied
with the enclosure (FIG. 8). Refer to B in FIG. 5 on page 5 for more information.
FIG. 8 Screw locations for plasterboard mounting of the main AXD unit
11. Place the faceplate on a level surface with the internal side up. Take the plastic pushbuttons and
insert them (engraved side down) into the six holes on the faceplate (FIG. 4 on page 4). Make
sure that they are secured firmly into place before attaching the faceplate.
12. Carefully snap on the faceplate (A in FIG. 5) to the main touch panel unit. Make sure the
plastic buttons are flush against the faceplate and secure.
13. Reconnect the AXlink wiring to the Central Controller. The touch panel beeps when power is
applied.

Mounting the Decor-style panel on plasterboard/drywall

To install Decor-style touch panels on plasterboard/drywall:
1. Carefully remove the Decor faceplate (A in FIG. 9) from the main AXD unit (B in FIG. 9) by
gripping the faceplate from the notches (located along the underside of the plate) and pulling
with gentle force.
Install the 2 drywall
clips and screws
(included) into the
A
- Decor
faceplate
FIG. 9 Decor-style panel installation configuration for drywall surfaces
4" Color Touch Panels
Surface mount screws (#4 wood)
are inserted through the
outer holes along the plastic housing
Main AXD unit consists of
illumination board, CP4, and
plastic housing
holes
Flat surface
(can include a
wall, podium, or
other level
surface)
2 notches are
required if the unit
is installed into a
drywall using the (2)
provided clips.
B - Main AXD unit consists of the touch
panel, illumination board, and housing
Installation
7