Lcd Timer; Serial Number, Axlink, And Vx.xx - AMX LCD Mini-Touch Panels Instruction Manual

Note
You can override the Beep
value setting using the 'ABEEP'
and 'ADBEEP' System
Send_Commands. Refer to the
AXCESS Programming
subsection for complete
information.
Figure 78
LCD TIMER button
Figure 79
SERIAL NO., AXlink, and
vX.XX button examples
Black/White LCD Mini-Touch Panels
Set the beep value to 0 to disable the beep sound. Press the up and down arrows to
set the beep time in .10-second increments . The minimum beep time setting is 0 and
the maximum is 10 (1 second).

LCD timer

The LCD TIMER button ( Figure 78) sets the length of time the mini-touch panel can
be inactive before activating screen-saver mode.
LCD TIMER
15
UP DN
When the mini-touch panel goes into screen-saver mode, the LCD is powered-down.
With a setting of 5, the panel goes into screen-saver mode if there is no activity for 5
minutes. Press the up and down arrows to change the time that the timer screen
stays on when there is no panel activity. The minimum time setting is 1 and
maximum is 150.

Serial number, AXlink, and vX.XX

The SERIAL NUMBER, AXlink, and vX.XX buttons shown in Figure 79 are non-
active (display only) buttons.
SERIAL NO.
AXlink
933 -00- 0001
The SERIAL NUMBER button shows the serial number AMX assigns to the mini-
touch panel. The AXlink button is an AXCESS communication indicator that blinks
once every second when the AXCESS Control System is connected to the mini-touch
panel. The vX.XX button shows the current ROM software version installed in the
mini-touch panel.
vX.XX
Mini-Touch Panel Program Reference 51