Figure 2-8. Removing The Icon Pca And Display Assembly - HP OMNIBOOK 2100 Service Manual

Icon PCA
Screw, M2.5×5mm
Note: Two screws
secure the cable for
a 12" display.
Reassembly Notes
After connecting the inverter/MB cable from the right hinge, carefully dress the wires into the
cutout and support in the top case.
Caution
For a 12-inch display, tuck the excess length of the LCD flex cable under the keyboard. The
cable could be damaged if there is excess length in the hinge area.
Use a 5 mm screw to fasten the LCD cable. If you use a longer screw, it will damage the
motherboard.
Do not overtighten the screws for the LCD cable. They fasten to a sheet-metal bracket and
the threads could strip.
Insert the right end of the icon PCA between the plastic tabs on the case. Check that the IR/icon
cable is not pinched and emerges above the PCA.
Slide the open end of the hinge cover onto the hinge, then lift the closed end over the bump and
slide it in.
HP OmniBook 2100/3000/3100

Figure 2-8. Removing the Icon PCA and Display Assembly

Screw, M2.5×8mm
Note:
13-inch display shown.
For a 12-inch display, the
display cables differ.
Removal and Replacement 2-11