Pull Rope - Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual

�
Tools Needed: Locate the center stile on the bottom
section of the door.
Pencil
On the outside of the door, position step
plate directly above astragal retainer.
1/4" Wrench
using the step plate as a template,
mark hole locations for mounting on
door face.
Drill (2) 5/16" dia. holes through the
door face and insulation, if necessary, at
marked locations, being careful to keep
drill straight.
Mount step plates back to back,
straddling stile. Secure with
(2) 1/4 x 2-3/4" carriage bolts and 1/4"-
20 flange hex nuts.
NOTE: After completing this step,
continue with Step 13 on page 18.
�
wARNINg
Tools Needed:
DO NOT INSTALL PuLL ROPES
Power Drill
ON DOORS WITh ELECTRIC
Drill Bit
OPERATORS. ChILDREN MAy
BECOME ENTANGLED IN ThE
ROPE CAuSING SEVERE OR
fATAL INjuRy.
Measure and mark the jamb
approximately 48" to 50" (1220 to 1270
mm) from floor on the right or left side
of door. Drill 1/8" pilot hole for No. 6
screw eye. Tie the pull rope to the No.
6 screw eye and to the bottom bracket
as shown.
34
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Step Plate

Pull Rope

BOTTOM
SECTION
STEP PLATE
(2) 1/4"-20 fLANGE hEx NuT
INSIDE STEP PLATE INSTALLATION
BOTTOM
SECTION
STEP PLATE
(2) 1/4 x 2-3/4"
CARRIAGE BOLTS
OuTSIDE STEP PLATE INSTALLATION
NO. 6 SCREW EyE
PuLL ROPE
PuLL ROPE
BOTTOM
SECTION
STEP PLATE
ASSEMBLy
BOTTOM SECTION
STEP PLATE ASSEMBLy
BOTTOM BRACkET