Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 14

5
Tools Needed: Locate the lower (numbered) leaf of
the #1 end hinges and required center
Power Drill
hinges over the #1 and #4 holes in the
end stiles for the end hinges and the
7/16" Socket
pre-punched holes in the center stile(s)
Driver
for the center hinges at the top of the
section.
NOTE: The #1 hinges serve as end
hinges on the bottom section. The #1
hinges also serve as center hinges at all
center hinge locations.
Secure the hinges to the section using
(2) 1/4"-14 x 5/8" self tapping screws
on each hinge leaf.
Insert roller into appropriate hinge tube.
Repeat for all other sections using the
#2 end hinges on the second (lock
section) and the #3 end hinges on the
third section (intermediate section).
NOTE: #4 End hinges are used on fourth
section of five section doors.
IMPORTANT: WhEN PLACING ROLLERS
INTO END hINGES NuMBER 2 AND
hIGhER, ThE ROLLER GOES INTO ThE
TuBE fuRThEST AWAy fROM SECTION.
IMPORTANT: ONCE fASTENER IS
SNuG AGAINST hINGE LEAf, TIGhTEN
AN ADDITIONAL 1/4 TO 1/2 TuRN TO
RECEIVE MAxIMuM DESIGN hOLDING
POWER.
14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
hinges
END STILE hOLE
(LEfT SIDE IS ShOWN.
1
2
3
4
5
6
7
PATTERN
CENTER STILE
hOLE PATTERN
RIGhT SIDE IS
OPPOSITE.)
#1 hOLE
#4 hOLE
END STILE
END hINGE PLACEMENT
CENTER STILE
CENTER hINGE PLACEMENT
ROLLER
PLACEMENT
#1 hINGE #2 END hINGE
ROLLER
PLACEMENT
ROLLER
PLACEMENT
#3 END hINGE #4 END hINGE
hINGE
(2) 1/4"-14 x 5/8"
SELf TAPPING
SCREWS
hINGE
(2) 1/4"-14 x 5/8"
SELf TAPPING
SCREWS