Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 20

15
Tools Needed:
To install horizontal track, place the curved end over
the top roller. Align the bottom of the horizontal track
9/16" Socket
with the vertical track. hand tighten the horizontal
track to the flagangle with (2) 1/4"-20 x 5/8" carriage
Ratchet Wrench
bolts and (2) 1/4"-20 flange hex nuts.
9/16" Wrench
Level the horizontal track assembly and bolt the
Level
horizontal angle to the slot in the flagangle using
(1) 3/8"- 16 x 3/4" hex head bolt and (1) 3/8"-16 hex
nut. Repeat for other side. Remove the nail that was
temporarily holding the top section in place, installed
in Step 13.
IMPORTANT: fAILuRE TO REMOVE NAIL BEfORE
ATTEMPTING TO RAISE DOOR COuLD CAuSE
PERMANENT DAMAGE TO TOP SECTION.
DO NOT RAISE DOOR uNTIL hORIzONTAL TRACkS
ARE SE CuRED AT REAR, AS OuTLINED IN STEP
34, OR DOOR COuLD fALL fROM OVERhEAD
POSI TION CAuSING SEVERE OR fATAL INjuRy.
NOTE: If an
horizontal tracks slightly above level.
16
Adjusting Top brackets
With horizontal tracks installed you can
Tools Needed:
adjust the top brackets.
7/16" Wrench
Vertically align the top section with the
lower sections. Once aligned, position
the top roller in the top bracket slide out
against the horizontal track. Maintaining
the slide's position, tighten 1/4"- 20
flange hex nut to secure the top bracket
slide to the top bracket base.
Repeat for other side.
20
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
horizontal Track
wARNINg
idrive
opener will be installed, position
®
(2) 1/4"-20 fLANGE
hEx NuTS
fLAGANGLE
(1) 3/8"-16
hEx NuT
TOP
SECTION
CORRECT
TOP
SECTION
TOP
SECTION
INCORRECT
fLAGANGLE
(2) 1/4"- 20 x 5/8"
CARRIAGE BOLTS
(1) 3/8-16 x 3/4"
hEx hEAD BOLT
hORIzONTAL
ANGLE
hORIzONTAL
TRACk
TOP ROLLER
TOP BRACkET
SLIDE