Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 17

9
Tools Needed:
NOTE: Doors with a keyed lock do not require this lift
handle.
Tape Measure
NOTE: for door section identification see page 4.
Pencil
Locate the inside center stile or the desired lift handle
Power Drill
location on the lock (2nd) section of the door. Position
9/32" Drill Bit
the lower hole in the lift handle 4" from the bottom of
the second section.
1/2" Drill Bit
IMPORTANT: The distance between the step/lift
1/4" Wrench
plate and the middle of the lift handle must be 20"
minimum to 30" maximum. If needed reposition upper
lift handle to stay within the required dimension.
Drill (2) 9/32" dia. holes through section. Enlarge the
holes from outside the door to 1/2" dia.
Assemble the outside and inside lift handle to the
section using (2) 1/4" x 2-1/2" carriage bolts,
( 2) 1/4"- 20 hex nuts and (2) spacers.
NOTE: Do not drill through or enlarge holes on the
inside of the door.
10
bottom Section
Tools Needed:
Before installing the bottom section,
the weather seal (may not be included)
Level
must be installed (see PREPARING ThE
OPENING on page 10)
Wood Shims
Center the bottom section in the door
opening. Level section using wooden
shims under the bottom astragal if
necessary. hold the section in the
opening while attaching vertical tracks.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
lift handle
jAMB
LOCk
SECTION
LIfT
hANDLE
4"
(2) SPACERS
(2) 1/4" x 2-1/2"
BOTTOM
CARRIAGE BOLTS
SECTION
LIfT hANDLE OuTSIDE
LOCk
SECTION
BOTTOM
SECTION
LIfT
(2) 1/4"-20
hANDLE
hEx NuT
BOTTOM SECTION
LIfT hANDLE INSIDE
hEADER
WEAThER
SEAL
LEVEL
WOODEN
ShIMS
LOCk
SECTION
LIfT
hANDLE
20" TO 30"
jAMB
BOTTOM
SECTION
17