Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 27

26
Attaching Disconnect Cables
Tools Needed: NOTE: See idrive
owners manual for idrive
Pliers
Attach the loose disconnect cable
(located in opener hardware bag) to the
opener with the "S" hook. Close both
ends of the "S" hook to lock assembly
together with pliers.
Thread the disconnect cable (behind the
counterbalance cable) through the hole
in the right hand end bracket, and
remove all slack between opener and
right end bracket.
27
Mounting Disconnect
handle bracket
Tools Needed:
NOTE: See idrive
owners manual for idrive
Pencil
Mark a location on the right jamb, 6
Tape Measure
feet above the floor to mount the
disconnect handle bracket.
1/8" Drill Bit
Drill 1/8" pilot holes for the lag screws.
7/16" Socket
Driver
Align top of the bracket with the mark.
Power Drill
fasten bracket to the jamb with
(2) 1/4" x 1-1/2" hex head lag screws.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
main installation and
®
parts.
®
RIGhT SIDE Of
END BRACkET
main installation and
®
parts.
®
S-hOOk
hOLE IN
END BRACkET
6ft
DISCONNECT
CABLE
hOLE IN RIGhT
END BRACkET
CLOSE "S" hOOk
(2) 1/4 x 1-1/2"
hEx hEAD LAG
SCREWS
DISCONNECT
hANDLE BRACkET
27