Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 29

29
for Spring winding
Place vice clamps onto both vertical
Tools Needed:
tracks just above the third roller. This is
(2) Vice Clamps
to prevent the garage door from raising
while winding counterbalance spring(s).
wARNINg
fAILuRE TO PLACE VICE CLAMPS
ONTO VERTICAL TRACk CAN
ALLOW DOOR TO RAISE AND
CAuSE SEVERE OR fATAL
INjuRy.
IMPORTANT: DO NOT uSE IMPACT GuN
TO WIND SPRING(S).
30
Cable Adjustments
Tools Needed:
Rotate the cable drum until the set
screw faces directly away from the
Locking Pliers
header. TorqueMaster
flat Tip peak should be pointing straight up.
Screwdriver
Beginning with the right side, loosen
the set screw approximately two turns,
Wire Cutters
to adjust cable. using locking pliers,
pull on the end of the cable to remove
all cable slack.
Check to ensure the cable is aligned
and seated in the first groove of the
cable drum. Snug the set screw, then
tighten an additional 1-1/2 turns. Cut
excess cable.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Securing Door
spring tube cam
®
COuNTERBALANCE
CABLE
CABLE
DRuM
CAM PEAk
STRAIGhT uP
PLACE VICE
CLAMPS ABOVE
3RD ROLLER
VICE CLAMPS
TRACk
ATTAChED TO
INNER RAIL
Of TRACk
SET SCREW
29