Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 22

19
NOTE: See idrive
Tools Needed:
owner's manual for idrive
None
IMPORTANT: RIGhT AND LEfT hAND
IS ALWAyS DETERMINED fROM INSIDE
ThE GARAGE LOOkING OuT.
Lay the TorqueMaster
the floor (inside garage) in front of the
door with the labeled end to the left.
Look into the opener's left side to
ensure the left hand bearing and the
internal (black) sleeve are aligned with
the TorqueMaster
IMPORTANT: hOLD OPENER By ThE
MAIN BODy. DO NOT hOLD By ThE
MOTOR.
NOTE: Opener will not slide over the
TorqueMaster
Attempting to slide opener over the left
end of the TorqueMaster
can damage the internal electronics.
Once aligned, slide the opener onto the
right hand end of the TorqueMaster
spring tube. As the right end of the
TorqueMaster
internal (black) sleeve, rotate the
opener back and forth slightly to help
aid alignment.
Continue sliding the opener onto the
TorqueMaster
right hand bearing with the
TorqueMaster
the opener completely onto the
TorqueMaster
TorqueMaster
opener right hand bearing.
NOTE: Do not force the opener onto the
TorqueMaster
misalignment occurs.
Continue sliding the opener to the
center of the TorqueMaster
tube.
Plug the motor power cord into the
opener.
22
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
idrive
Installation
®
main installation and
®
parts.
®
spring tube on
®
® spring tube profile.
spring tube label.
®
spring tube
®
®
® spring tube enters the
spring tube. Align the
®
spring tube and slide
®
spring tube until the
®
spring tube exits the
®
spring tube if
®
spring
®
LEfT hAND SIDE
TORquEMASTER SPRING TuBE
®
AND BEARING PROfILES ALIGNED
RIGhT hAND END
Of TORquEMASTER
®
SPRING TuBE
MOTOR
RIGhT hAND SIDE
TORquEMASTER
®
SPRING TuBE AND
BEARING PROfILES
ALIGNED
PLuG-IN MOTOR
POWER CORD