Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 24

21
Drive gear Installation
Tools Needed:
Beginning with the right hand side,
lubricate entire circumference of the
drive gear with the lubricating oil
provided. Slide the drive gear onto the
winding shaft splines until it touches
the flagangle.
NOTE: On single spring applications,
no drive gear is required on the left
side.
NOTE: If additional lubricating oil is
needed, use "Dura Lube
Treatment".
22
Tools Needed: IMPORTANT: WARNING TAGS MuST BE
SECuRELy ATTAChED TO BOTh END
Power Drill
BRACkETS.
3/16" Drill Bit
Slide the right hand end bracket over
the drive gear and fasten to the
7/16"
Socket Driver
flagangle using a #10 phillips head
screw.
Phillips head
Screwdriver
Drill 3/16" pilot holes into jamb for the
lag screws. Secure end bracket and the
flagangle to the jamb using
(2) 5/16" x 2" hex head lag screws.
24
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Engine Oil
®
End brackets
CABLE
DRuM
fLAGANGLE
(2) 5/16" x 2"
hEx hEAD LAG
SCREWS
LuBRICATING
WINDING
ShAfT
SPLINES
CABLE
DRuM
DRIVE GEAR
WINDING
ShAfT
END BRACkET
WARNING
#10 PhILLIPS
hEAD
SCREW
OIL
DRIVE
GEAR
TAG