Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 12

2
Installing Fully Adjustable Jamb
Tools Needed:
NOTE: If you have riveted track, skip
this step.
None
To attach the bottom jamb bracket,
jB-2, locate the first set of quick install
features of the vertical track. Align
the slot in the jamb bracket with the
slot above the quick install features in
the vertical track. The long side of the
bracket is placed against the track.
fasten the jamb bracket finger tight,
using (1) 1/4"- 20 x 5/8" carriage bolt
and (1) 1/4"- 20 flange hex nut.
To attach the top jamb bracket, jB-3,
locate the third set of quick install
features of the vertical track. Align
the slot in the jamb bracket with the
slot above the quick install features in
the vertical track. The long side of the
bracket is placed against the track.
fasten the jamb bracket finger tight,
using (1) 1/4"- 20 x 5/8" carriage bolt
and (1) 1/4"- 20 flange hex nut.
3
Tools Needed:
NOTE: for door section identification see
page 4.
Power Drill
Align the center hole of bottom bracket
7/16" Socket
with hole #3 in the end stile of bottom
Driver
section. fasten with (2) 1/4"-20 x 11/16"
self drilling screws and (1) 1/4"-20 x 5/8"
tamper-proof self drilling screw as shown.
Repeat for other side.
NOTE: Only doors provided to professional
installers, who have required tools will be
supplied with a tamper-resistant fastener.
use a 1/4"-20 x 11/16" self drilling screw
in the bottom bracket, if not provided with
a tamper-resistant screw.
12
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
brackets
bottom bracket
fuLLy ADjuSTABLE
jAMB BRACkET
jAMB BRACkET
SLOT
(1) 1/4"-20
quICk INSTALL
fLANGE
fEATuRE
hEx NuT
jAMB BRACkET
quICk INSTALL
fEATuRE
LEfT hAND
BOTTOM BRACkET
#3 hOLE
7
BOTTOM
BRACkET
6
5
4
3
2
1
END STILE hOLE
BOTTOM
PATTERN
BRACkET
(LEfT SIDE IS ShOWN.
RIGhT SIDE IS
OPPOSITE.)
3RD SET
(1) 1/4"- 20 x 5/8"
CARRIAGE BOLT
VERTICAL
TRACk
1ST SET
VERTICAL
TRACk
(2) 1/4"-20 x 11/16"
SELf DRILLING
SCREWS
(1) 1/4"- 20 x 5/8"
TAMPER-RESISTANT
SELf DRILLING
SCREW
CENTER hOLE
WARNING
LABEL
BOTTOM
SECTION