Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 31

33
Drum wrap Installation
Tools Needed: Drum wraps are identified as right and
left hand.
None
To install, place the drum wrap over the
cable drum and under the idrive
disconnect cable (right hand side). Align
the outside flange over the outside edge
of the cable drum and push the drum
wrap down onto the cable drum. Repeat
for left hand side.
NOTE: Drum wraps must be installed to
prevent cable from becoming tangled.
IMPORTANT: RIGhT AND LEfT hAND
ARE ALWAyS DETERMINED fROM
INSIDE ThE GARAGE LOOkING OuT.
34
wARNINg
Tools Needed:
kEEP hORIzONTAL TRACk
Ratchet Wrench
PARALLEL AND WIThIN 3/4"
MAxIMuM Of DOOR EDGE,
1/2" Socket
OThERWISE DOOR COuLD fALL,
RESuLTING IN SEVERE INjuRy OR
1/2" Wrench
DEATh.
Raise the door until the top section and
(2) Vice Clamps
half of the next section are in a horizontal
position. Do not raise door any further
Tape Measure
since the horizontal tracks are not yet
supported at the rear.
Level
wARNINg
hammer
RAISING DOOR fuRThER CAN
RESuLT IN DOOR fALLING AND
CAuSE SEVERE INjuRy OR DEATh.
Clamp a pair of vice clamps on the vertical
tracks just above the second roller on one
side and below the second roller on the
other side. This will prevent the door from
raising or lowering while installing the rear
support.
using perforated angle, 5/16" x 1-5/8"
hex head lag screws and 5/16" bolts
with nuts (may not be supplied), fabricate
rear support for horizontal tracks. Attach
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
®
Rear Support
CABLE
DRuM
CABLE
DRuM
DOOR IN ThE
uP POSITION
3/4"
DOOR EDGE
hORIzONTAL TRACk
DRuM
WRAP
OuTSIDE
fLANGE
DRuM
WRAP
VICE
CLAMPS
VERTICAL
TRACk
31