Side Lock; Doormaster Tm Bracket - Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual

�
Install the side lock on the second
Tools Needed:
section of the door. Secure the lock to
Power Drill
the section with (4) 1/4"- 20 x 11/16"
7/16" Socket
self drilling screws. Square the lock
Driver
assembly with the door section and
Tape Measure
align with the square hole in the vertical
track. The side lock should be spaced
in approximately 1/8" from the section
edge.
IMPORTANT: SIDE LOCkS MuST BE
REMOVED OR MADE INOPERATIVE IN
ThE uNLOCkED POSITION If AN
OPERATOR IS INSTALLED ON ThE
DOOR.
NOTE: After completing this step,
continue with Step 13 on page 19.
�
DoorMaster
Tools Needed:
NOTE: When installing a DoorMaster
operator use the center bracket and
drive gear supplied with your operator
(located in DoorMaster
Slide the DoorMaster
gear assembly onto the TorqueMaster
spring tube, so that the drive gear/center
bracket assembly are in the center of
the TorqueMaster
NOTE: After completing this step,
continue with step 20 on page 23.
Tools Needed:
Locate the center bracket, mark the
Power Drill
header halfway between the flagangles
and level the TorqueMaster
tube. Drill 1/8" pilot holes for the lag
1/8" Drill Bit
screws. fasten the metal bracket to the
header using (2) 1/4" x 1-1/2" hex head
7/16" Socket
lag screws.
Driver
NOTE: After completing this step,
Tape Measure
continue with step 29 on page 29.
Level
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Side lock

A
bracket
TM
A
TM
package).
TM
bracket/drive
TM
®
spring tube.
®
b
b
DOORMASTER
BRACkET/ DRIVE
® spring
GEAR ASSEMBLy
(4) 1/4"- 20 x 11/16"
SELf DRILLING SCREWS
TM
DOORMASTER BRACkET/
DRIVE GEAR ASSEMBLy
TORquEMASTER ® TuBE
TM
1/8"
(2) 1/4" x 1-1/2" hEx
hEAD LAG SCREWS
33