Installation; Optional Installations - Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual

6
Align upper-center hole of top bracket
Tools Needed:
base with #6 hole in the end stile (See end
Power Drill
stile hole layout). Loosely secure with
(1) 1/4"- 20 x 7/8" self drilling screw.
7/16" Socket
Driver
Ensure top bracket is level and aligned
with edge of section. Secure with
(4) 1/4"- 20 x 7/8" self drilling screws,
one in each corner of the top bracket
base.
Remove the 1/4"- 20 x 7/8" self drilling
screw installed in the upper-center hole of
the top bracket base.
Loosely hand tighten top bracket slide
with (1) 1/4"- 20 x 5/8" carriage bolts and
(1) 1/4"- 20 flange hex nuts. Insert roller
and repeat for other side.
NOTE: for doors with a glazed top section
(windows). Top strut may be mounted
between #2 and #6 holes before top
bracket is installed. See Step 8 for u-Bar

installation

7
Tools Needed:
NOTE: for alternative step/ lift plate
installation, see "Step Plate" in the
Pencil
optional installations on page 34.
Power Drill
Locate the center most stile on the
bottom section of the door. using the
5/16" Drill Bit
pre-punched holes at the bottom of
Phillips the stile as a template, drill (2) 7/32"
Screwdriver
dia. holes through the section. using
the previously drilled holes as a guide,
enlarge the holes from outside the door
to 7/16" diameter. Assemble the outside
and inside step/lift plates to the section
using (2) #8 x 1-5/8" screws.
NOTE: Do not drill through or enlarge
holes on the inside of the door.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Top bracket
Step Plate
TOP BRACkET
#6 hOLE
END STILE
(1) 1/4"- 20 x 5/8"
CARRIAGE BOLT
BOTTOM
SECTION
OuTSIDE
STEP PLATE
STEP PLATE OuTSIDE
BOTTOM
SECTION
INSIDE STEP
PLATE
(2) #8 x 1-5/8" SELf
TAPPING SCREWS
STEP PLATE INSIDE
BASE
TOP SECTION
(4) 1/4-20 x 7/8" SELf
DRILLING SCREW
(1) 1/4"- 20
fLANGE hEx
NuT
TOP
BRACkET
SLIDE
TOP SECTION
TOP
BRACkET
BASE
TOP
BRACkET
ASSEMBLy
TOP SECTION
BOTTOM
SECTION
OuTSIDE
STEP PLATE
BOTTOM
SECTION
INSIDE STEP
PLATE
15