Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 26

25
Positioning Support bracket
NOTE: See idrive
Tools Needed:
owners manual for idrive
Power Drill
NOTE: idrive
1/8" Drill Bit
solid mounting surface.
7/16" Socket
Locate the mounting surface. The
Driver
mounting surface is a vertical board
Tape Measure
running directly above the center of the
door. Remove (2) 1/4"-20 flange nuts
from bottom of opener.
NOTE: Do not discard flange nuts.
Place the support bracket underneath
opener, to the right side of motor,
centered on mounting surface. using a
tape measure, level the bottom of the
TorqueMaster
the door section with the idrive
on the support bracket. Once
TorqueMaster
1/8" pilot holes for the lag screws. Then
secure support bracket to the mounting
surface with (2) 1/4" x 1-1/2" hex had
lag screws.
IMPORTANT: TORquEMASTER
TuBE MuST BE LEVEL AfTER SuPPORT
BRACkET IS fASTENED TO MOuNTING
SuRfACE.
NOTE: If wood mounting surface is
behind dry wall, use 1/4" x 2" lag
screws.
Lift and slide the opener over the
support bracket, aligning the mounting
studs with the bracket slots. Loosely
fasten to mounting studs with the (2)
1/4"-20 flange nuts.
NOTE: Do not tighten 1/4"-20 flange
nuts to opener studs at this time.
Remove the temporary orange label
holding the antenna wire. Straighten
antenna wire and angle it 45 degrees to
the right.
NOTE: Do not coil the antenna wire.
This will reduce the radio signal range.
26
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
main installation and
®
parts.
®
must be installed on a
®
spring tube to the top of
®
resting
®
® spring tube is level, drill
SPRING
®
45° ANGLE
1/4 x 1-1/2"
hEx hEAD
LAG
SCREWS
(hEADER)
TOP Of DOOR
TORquEMASTER
®
SPRING TuBE
"x"
uSING A TAPE MEASuRE, MAINTAIN AN EquAL MEASuREMENT "x" (TOP Of DOOR
TO BOTTOM Of TORquEMASTER® TuBE) AT BOTh ENDS AND ThE CENTER.
ANTENNA WIRE
TORquEMASTER
SPRING TuBE
SuPPORT
BRACkET
1/4" - 20
fLANGE
NuTS
MOuNTING
STuDS
MOuNTING
STuDS
BRACkET
SLOTS
(2) 1/4"-20
fLANGE NuTS
"x"
TOP SECTION
MOuNTING
SuRfACE
®
SuPPORT
BRACkET
"x"