Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 23

20
Cable Drum Installation
Tools Needed: Shake the TorqueMaster
gently to extend the winding shafts out
None
about 5" on each side.
NOTE: for single spring applications,
there will be no left hand spring in the
TorqueMaster
Lift the TorqueMaster
rest it on the top of the flagangles.
For idrive
®
TorqueMaster
of opener is flat against header/
mounting surface.
NOTE: Cable drums are marked right
and left hand. Cable drums and
TorqueMaster
shaped to fit together only one way.
To install the cable drum, slide the
correct cable drum over the winding
shaft until the cable drum seats against
the TorqueMaster
winding shaft must extend past the
cable drum far enough to expose the
splines and the groove.
Align the winding shaft groove with
the round notch in the flagangle.
For double spring applications:
Repeat for opposite side.
For single spring applications: Insert
the loose winding shaft into the left
hand cable drum prior to sliding the
cable drum over the TorqueMaster
spring tube.
NOTE: On single spring applications,
take care in handling the loose winding
shaft (left side) so that it does not slide
back into the TorqueMaster
tube.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
spring tube
®
TORquEMASTER
spring tube.
®
spring tube and
®
operated doors: Orient
spring tube so that back
®
spring tube are cam
®
spring tube. The
®
®
spring
®
GROOVE
®
SPRING TuBE
WINDING
ShAfT SPLINES
RIGhT hAND
CABLE DRuM
TORquEMASTER
®
SPRING TuBE
RIGhT hAND
CABLE DRuM
fLAGANGLE
TORquEMASTER
®
SPRING TuBE
RIGhT hAND
CABLE DRuM
left hand Side
Single Spring Application
GROOVE
LOOSE
WINDING
ShAfT
LEfT hAND
CABLE DRuM
COuNTERBALANCE
CABLE
fLAGANGLE
WINDING
ShAfT GROOVE
ROuND
NOTCh
ROuND
NOTCh
WINDING
ShAfT
TORquEMASTER
®
SPRING TuBE
ROuND
NOTCh
23