Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 21

17
TorqueMaster
Tools Needed:
TorqueMaster
and pre-assembled inside the
None
TorqueMaster
the TorqueMaster
floor (inside garage) in front of the door
with the labeled end to the left.
IMPORTANT: RIGhT AND LEfT hAND IS
ALWAyS DETERMINED fROM INSIDE ThE
GARAGE LOOkING OuT.
18
Center bracket bushing
Tools Needed:
NOTE: If you are installing an idrive
opener on your garage door, skip this
None
step and continue with Step 19.
NOTE: If you are not installing an idrive
opener on your garage door, you must
install the center bracket bushing
assembly. follow these instructions for
non-idrive
®
NOTE: If you are installing a
DoorMaster™ opener, see optional
DoorMaster™ Bracket installations on
page 33, figure A.
Being cam shaped the center bracket
bushing only fits one way.
Slide the center bracket assembly
towards the center of the torque tube,
from the right side as shown.
NOTE: upon completion of this step,
continue with Step 20.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Spring Tube
®
® springs come lubricated
spring tube. To install, lay
®
spring tube on the
®
®
®
operated garage doors.
TORquEMASTER
LABELED END
TORquEMASTER
®
SPRING TuBE
®
SPRING TuBE
CENTER
BRACkET
ASSEMBLy
TORquEMASTER
®
SPRING TuBE
CENTER
BRACkET
BuShING
21