Wayne-Dalton 8000 SERIES Installation Instructions And Owner's Manual page 19

13
Place the top section in the opening and
Tools Needed:
vertically align with lower sections.
hammer
Temporarily secure the top section by
Nail
driving a nail in the header near the
center of the door and bending it over
Power Drill
the top section.
7/16 Socket
Now flip up the hinge leaf against
Driver
section, fastening center hinges first and
end hinges last.
14
Tools Needed: When installing a door with a
TorqueMaster
Power Drill
vertical track alignment is critical.
Position flagangle between 1-11/16"
7/16 Socket
(43 mm) to 1-3/4" (44 mm) from the
Driver
edge of the door. Tighten the bottom lag
Tape Measure
screw. flagangles must be parallel to the
door sections. Repeat for opposite side.
IMPORTANT: ThE DIMENSION BETWEEN
ThE fLAGANGLES MuST BE DOOR
WIDTh PLuS 3-3/8" (86MM) TO 3-1/2"
(89 MM) fOR SMOOTh, SAfE DOOR
OPERATION.
Complete the vertical track installation
by securing the center jamb bracket(s)
and tightening the other lag screws.
Push the vertical track against the rollers
so that the rollers are touching the
deepest part of the curved side of the
track (see illustration). Tighten all the
track bolts and nuts. Repeat for opposite
side.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Top Section
vertical Track
counterbalance system,
®
NAIL
fLAGANGLE
VERTICAL TRACk
ROLLER
ROLLER AGAINST
VERTICAL TRACk
DOOR WIDTh
+3-3/8" TO 3-1/2"
1-11/16" TO 1-3/4"
TOP SECTION
19