Config Gvrp - D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual

config gvrp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
91
To configure GVRP on the Switch.
config gvrp [<portlist> | <ch1-32> | all] { state [enable | disable]
{ ingress_checking [enable | disable] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
The config gvrp command configures the Group VLAN Registration
Protocol on the Switch. The user can configure ingress checking and
acceptable frame tagged only, the sending and receiving of GVRP
information, and the Port VLAN ID (PVID).
<portlist> − A port or range of ports for which to configure GVRP.
ch 1-32 − configure GVRP on LAGs.
all − configure GVRP on ports.
state [enable | disable] - enable and disable GVRP
ingress_checking [enable | disable] − Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – Defines the type of
frame accepted. Acceptable frames can be limited to tagged frames
only (tagged_only) or can accept tagged and untagged (admit_all).
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port, by VLAN ID.
Only administrator or operator-level users can issue this command.
DGS3100# config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DGS3100#
To enable GVRP on the Switch.
enable gvrp
The enable gvrp command, along with the disable gvrp command
below, is used to enable and disable GVRP on the Switch, without
changing the GVRP configuration on the ports and the LAGs.
None.
Only administrator or operator-level users can issue this command.
DGS3100# enable gvrp
Success.