Removing Dc Pems - Cisco 12410 Installation And Configuration Manual

Removing Components Before Installing the Chassis

Removing DC PEMs

Step 1
Warning
Step 2
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
3-10
Use the following procedure to remove the DC PEMs from the chassis.
Remove the PEM from the chassis
Loosen the captive screw on the ejector lever.
a.
Pivot the lever down to eject the PEM from its bay.
b.
Slide the PEM out of its bay while supporting it with your other hand.
c.
The DC PEM weighs approximately 14 pounds (6.35 kg). Use two hands to
remove the power supply.
Figure 3-6 Removing a DC PEM
Repeat Step 1 for the other PEM.
Chapter 3
(Figure 3-6):
Installing the Router
OL-11496-01