Removing And Replacing The Cisco Asr 1001-X Router Dimm; Removing And Replacing The Cisco Asr 1001-X Router Dimm Memory Module - Cisco ASR 1001-X Hardware Installation Manual

Removing and Replacing the Cisco ASR 1001-X Router DIMM

This completes the USB Flash memory installation procedure.

Removing and Replacing the Cisco ASR 1001-X Router DIMM

This section describes how to replace the DIMMs on the Cisco ASR 1001-X Router.
The Cisco ASR 1001-X Router supports an 8-GB and 16-GB configuration.
Note
You might have to upgrade a DIMM for the following reasons:
• You have upgraded to a new Cisco IOS feature set or release that requires more memory.
• You are using very large routing tables or many protocols.

Removing and Replacing the Cisco ASR 1001-X Router DIMM Memory Module

Perform the following steps before you begin the process of removing and replacing a DIMM memory module:
• Use an ESD-preventive wrist strap.
• Back up the data that you want to save.
• Remove the power supplies before you remove the chassis top cover.
Caution The top cover cannot be removed until the power supplies are removed from the chassis. The chassis has
a safety mechanism built in to prevent the removal of the top cover until the power supplies are removed.
• The DIMM component is keyed and slotted for easier connection.
• The Cisco ASR 1001-X Router has two DIMM slots.
The below table shows the slots that are supported for inserting the memory DIMMs in the Cisco ASR1001-X
Router.
Table 23: Supported Slots for Inserting the DIMMs
Memory PID Option
U1D0
U1D1
Cisco ASR 1001-X Router Hardware Installation Guide
102
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Slot 0 (U101D)
4 GB
8 GB
Slot 1 (U103D)
4 GB
8 GB