Boiler Block Assembly; Assembly Of A Boiler Block From Sections - Buderus Logano G315 Installation And Service Instructions Manual

7

Boiler block assembly

7 Boiler block assembly
WARNING: Risk of injury from improperly
secured boiler sections.
B Use only suitable means of transportation
when handling the boiler sections, e.g.
a heavy duty hand truck. When handling,
secure the boiler sections to the means of
transport to prevent them slipping.
6
5
4
3
2
1
Fig. 7 Boiler heat exchanger
Key to Fig. 7:
1 Boiler base or foundation
2 Draining
3 Exhaust Manifold
4 Rear section
5 Return connection
6 Supply connection
7 Intermediate sections
8 Tie rod
9 Directional arrow
10 Front section
11 Burner door with burner plate
Depending on the type of delivery, we distinguish
between delivery unassembled and as a ready
assembled block. When delivered as a ready-
assembled block, the boiler is assembled and checked for
leaks prior to despatch. If, because of physical limitations,
a boiler block cannot be assembled as a complete unit,
delivery unassembled would enable assembly on site.
For details of assembling the remainder of the
boiler if the heat exchanger is delivered pre-
assembled, see Chapter 7.3, page 23.
18
7 8
9
10
11
8
6 720 642 621-03.1o
7.1 Assembly of a boiler block from
sections
WARNING: Risk of injury from inadequately
secured boiler sections.
B Secure boiler sections during assembly
and take measures to prevent them from
tipping over. If a hoisting tool is available,
this can be used to set up the boiler
sections safely.
The boiler block is always installed starting from the rear
with the rear section (Fig. 7, [4]) and working towards the
front. The front section (Fig. 7, [10]) is always fitted last.
Observe the directional arrows (Fig. 7, [9]) during
assembly and carry this out in accordance with the
following instructions and illustrations.
Fig. 8 Rear section
Logano G315 - Subject to technical modifications