Fitting Side Panels And Top Covers - Buderus Logano G315 Installation And Service Instructions Manual

7.9.3

Fitting side panels and top covers

B Attach side panel (Fig. 37, [1]) with the cut-outs into
the slots of the top connection plates (Fig. 37, [2]) and
push forwards as far as it will go.
B Screw the side panels at the bottom to the bottom
profile rails using two self-tapping screws in each case
(Fig. 37, [3]).
Fig. 37 Fitting the side panels
B Place front cover (Fig. 38, [1]) between the side panels
so the cut-out (Fig. 38, [3]) fits over the tie bar.
B Screw the rear cover to the side panels using one self-
tapping screw per panel (Fig. 38, [2]).
Fig. 38 Fitting the front cover
Logano G315 - Subject to technical modifications
Boiler block assembly
Before fitting the other parts of the cover, you
must first install the control panel, route the
capillary tubes to the sensor well and insert the
sensor into the sensor well (
page 34).
B Place rear cover (Fig. 39, [1]) between the side panels
so the cut-out (Fig. 39, [2]) fits over the tie bar.
Fig. 39 Fitting the rear cover
Push the base rails (Fig. 40, [2]) onto the bottom folded
edges of the side panels and screw on at the side using
one self-tapping screw in each case (Fig. 40, [1 and 3]).
Fig. 40 Fitting the front base rail
7
Chapter 9,
31