Boiler Block Assembly; Assembly When Delivered In Sections; Preparation Of Boiler Sections - Buderus Logano G225 Installation And Service Instructions Manual

5

Boiler block assembly

5 Boiler block assembly
The on-site installation is carried out using individual
sections if, because of physical limitations, a boiler block
cannot be handled as a complete unit.
For details of assembling the remainder of the boiler if the
heat exchanger is delivered pre-assembled,
Chapter 5.4, page 28.
Warning: Risk of injury if load is
inadequately secured during transportation.
V Use suitable means of transportation, e.g.
the Buderus boiler hand truck with strap.
V Secure the load against falling.
5.1 Assembly when delivered in
sections
V Assemble all boiler sections in accordance with the
following instructions and illustrations.
5.1.1

Preparation of boiler sections

V Lay rear section [2] across two wooden battens [3].
V Clean the boiler bosses [1] with emery paper and a rag.
V Remove any burrs which might have been created with
a file.
V Clean the joint lip/groove [4] using a wire brush and
rag.
Warning: Health risk and risk of injury from
release of vapours and easily combustible
cleaning agents.
V Ensure adequate ventilation inside the
boiler room when using red lead putty,
adhesives and cleaning agents.
V When using a cleaning agent, avoid naked
flames, glowing embers and sparks.
V Observe the manufacturer's handling and
safety instructions.
16 Logano G225/Logano plus GB225 - We reserve the right to make any changes due to technical modifications.
5
4
3
2
1
Fig. 4 Fully assembled boiler heat exchanger
1 Foundation/installation location
2 Drain
3 Rear section
4 Flue outlet
5 Connecting block
6 Centre sections
7 Anchor rods
8 Front section
9 Burner door
2
1
Fig. 5 Filing off flash
1 Boiler bosses
2 Rear section
3 Wooden battens
4 Joint lip
6 7
8
9
7
6 720 615 876-04.1RS
1
4
3
6 720 615 876-05.1RS