Setting The Units Of Measure - Honeywell BENDIX/KING KLN 94 Pilot's Manual

Chapter 5 Intermediate Operation
To enter the local magnetic variation manually on the SET 2 page:
1. Turn on the cursor (B).
2. Move the cursor over the field on
line 4 (figure 5-114).
3. Turn the right inner knob to
change the magnetic variation
field from Auto to Manual if
required (figure 5-115).
4. Use the right outer knob to move
the cursor over the numerical
value on line 5.
5. Use the right inner and outer
knobs to select the magnetic
variation, from 0 to 99 degrees.
6. Move the flashing part of the cur-
sor to the E/W (east/west) field
and select whether the magnetic
variation is easterly or westerly
(figure 5-116).
7. Press F to approve and turn the cursor (B) off.

5.17. SETTING THE UNITS OF MEASURE

The SET 12 page (figure 5-117) is
used to set the unit of measure for
various parameters. The altimeter
barometric setting can be set to inch-
es of Mercury ("), millibars (mB), or
hectopascals (hP). Altitude, airport
elevation, and runway lengths can be
set to feet (ft) or meters (m). Finally, distances and velocities can be set to
nautical miles (NM) and knots (kt) or kilometers (km) and kilometers/hour
(k/h). To change a unit of measure: select the SET 12 page; turn on the
cursor (B) and move it over the desired unit of measure using the right
outer knob; turn the right inner knob to select the desired unit of measure;
and turn the cursor off again.
Figure 5-114
Figure 5-115
Figure 5-116
Figure 5-117
5-42