Honeywell BENDIX/KING KLN 94 Pilot's Manual page 231

Honeywell gps receiver user manual
Hide thumbs Also See for BENDIX/KING KLN 94:
Table of Contents

Advertisement

KLN 94 Pilot's Guide
Appendix B Message Page Messages
Nav Data Referenced To
User-Defined Mag Var - This message appears when a user-defined
magnetic variation other than 0 degrees is being used for navigation data.
NAV Super Flag Failure — This message appears when an internal test
fails for a specific NAV flag output. The KLN 94 is still usable, but any-
thing connected to the super flag (such as some HSIs and autopilots)
should not be used with the KLN 94.
No Database Card. LAND
Data Removed On Map.
Insert Card And
Cycle Power.— This message appears if the database card is removed
while the KLN 94 is operating. The land data (rivers, roads, cities, etc.) will
no longer be displayed on the map with the card removed. However, the
aeronautical data (airports, navaids, special use airspace, flight plan way-
points, etc.) will continue to be properly displayed on the map and the unit
will otherwise work normally. To display land data the database card must
be re-inserted and the power must be turned off and then back on.
Applicable to ORS 02 and higher units only.
No GEN RS-232 In Data — This message appears when no input is
received on the RS-232 input (such as from a fuel management or air
data system).
No GPS Receiver Data - This message appears when the KLN 94 fails a
specific internal test for the GPS receiver. This failure will prevent the unit
from providing any navigation capability.
OBS Waypoint > 200nm - (or OBS Waypoint >370 km) This message
is displayed when the KLN 94 is in the OBS mode and the distance to the
active waypoint is more than 200 nautical miles or 370 kilometers.
Other WPTs Deleted - (Other waypoints deleted) This message is dis-
played whenever more than 10 waypoints used in a flight plan (including
the active waypoint) have been deleted.
Position of _______ has Changed — This message appears when
either the latitude or the longitude of a waypoint used in a flight plan or the
active waypoint has changed by more than .33 minutes as a result of
updating the database.
Positions of Other WPTs Have Changed — This message appears
when the above message " Position of _______ has Changed" would be
effective for more than ten waypoints.
Press ALT To Set Baro — This message appears when the approach
mode is armed. Press the A button to update the barometric pressure
for proper integrity monitoring.
B-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents