Honeywell BENDIX/KING KLN 94 Pilot's Manual page 183

KLN 94 Pilot's Guide
3. The cursor will normally already be over the desired airport but if you
wish to select another airport from the list use the right outer knob to
move the cursor to the desired airport. Press F.
NOTE: If the desired airport is not in the list, turn the right outer knob
clockwise to move the cursor to the blank position at the end of the list.
Enter the airport identifier of the airport where the approach is to be con-
ducted. Press the F button once to view the APT 1 page and a second
time to approve it.
4. The APT 8 page is displayed showing a list of approaches for the
selected airport (figure 6-8).
Those approaches approved for
GPS have the letters GPS to the
right of the approach name. The
cursor will be on the first
approach in the list. Use the right
inner knob to move the cursor
over the desired approach. If
there are more than 4 approach-
es for the airport, the first three
approaches and the last one are
initially shown. Turn the right
outer knob to move the cursor
through the entire list and over
RNAV 17 (figure 6-9). Press F.
NOTE: Those approaches not having the letters GPS to the right of the
approach name are not approved for GPS. Therefore, the KLN 94 may
ONLY be used to provide situational awareness and monitoring for these
approaches. When a non-approved approach is selected a page is dis-
played for the pilot to acknowledge
by pressing the F button (figure 6-
10). When a non-approved
approach is selected the unit will
remain in approach arm mode (or
terminal mode) and will not transition
to the approach active mode.
5. A list of initial approach fixes
(IAFs) for the RNAV 17
approach in shown (figure 6-11).
In most cases Vectors, used
when radar vectors will be
received, is the first choice in
the list. In this example we want
the MIFEV IAF. Select this by
Chapter 6 Approaches and DP/STARs
Figure 6-8
Figure 6-9
Figure 6-10
Figure 6-11
6-7